0

Hanna Instruments (M) Sdn Bhd
11A, Jalan PJS 11/20,
Bandar Sunway,
46150 Petaling Jaya,
Selangor, Malaysia.
+603-5638 9940

Penang Branch Office
Hanna Instruments (M) Sdn Bhd
N0. 303-2-27, Krystal Point,
Jalan Sultan Azlan Shah,
11900 Sungai Nibong,
Penang, Malaysia.
+604-638 4558
+604-645 4558
penang@hannamalaysia.com

Sabah Branch Office
Hanna Instruments (M) Sdn Bhd

No. 4-1, 1st Floor,
Plaza Kingfisher,
Jalan Plaza Kingfisher 5,
Inanam, 88450 Kota Kinabalu,
Sabah, East Malaysia.
088-382 941
088-382 942
sabah@hannamalaysia.com


Measuring Dissolved Oxygen of Hydroponic Nutrient Solutions

Measuring Dissolved Oxygen of Hydroponic Nutrient Solutions.

In hydroponic growing systems, plants are grown in a soilless environment and receive all essential nutrients from a nutrient solution. These nutrient solutions are closely monitored for pH, EC/TDS, and specific nutrient concentrations; however, one parameter that is often overlooked is oxygen. Oxygen is essential for the development of a healthy root system, both for aerobic respiration of the roots and to support a community of beneficial aerobic bacteria in the root zone. Insufficient oxygen levels in the root zone will cause less developed roots, limited nutrient absorption, and an increased population of undesirable bacteria and fungi, all of which result in plant stress.

There are multiple types of hydroponic systems, but some of the most common include:
 deep water culture, where the plant roots are submerged in a nutrient solution;
 aeroponics systems, where the plant roots grow in air and are misted with a nutrient solution;
 nutrient film technique, where the very ends of roots are in contact with a surface wetted with nutrient solution;
 and drip or passive irrigation systems, where the plant roots grow in an inert media such as cocoa peat, rock wool, or perlite, and nutrient solution slowly drips through.

In systems where the roots are submerged, aeration of the nutrient solution is essential to ensure healthy root development. Dissolved oxygen (DO) levels of 5 mg/L and above are recommended, as levels below this are detrimental and possibly fatal to plants. However, a DO concentration of 5 mg/L is difficult to maintain in greenhouse environments. As the temperature of water increases, the solubility of oxygen decreases. The elevated temperatures in greenhouses result in low DO solubility, as well as higher root respiration and oxygen consumption. DO concentrations greater than 5 mg/L can be maintained by aeration. Aeration can be achieved by the use of air pumps and oxygen diffusers, additions of chemicals such as hydrogen peroxide or ozone, or physically by rapid mixing.

Application:

A nursery contacted Hanna Instruments for a way to monitor dissolved oxygen in their irrigation water. The nursery was utilising a combination of both soil-based growing methods and passive irrigation hydroponic systems, and wanted a way to measure DO in their reservoir tank as well as their hydroponic nutrient solution at various points throughout the greenhouse. The customer was supersaturating their irrigation water to 10 mg/L DO with an air pump and air stone. This was to ensure that levels would be maintained at 5 mg/L or above once the nutrients were added and the nutrient solution was trickled through the greenhouse. Hanna offered the HI2004 edge®DO Meter. The HI2004 edge®DO measures dissolved oxygen from 0.00 to 45.00 mg/L with 0.01 mg/L resolution and high accuracy of ±1.5% of reading ±1 digit. The slim, 12 mm diameter HI764080 polarographic DO probe allowed the customer to take in situ DO measurements of their nutrient solution throughout the greenhouse. The temperature component on the DO sensor allows for automatic temperature compensation to DO measurements, resulting in more accurate readings. Altitude and salinity compensation can also be enabled by simply entering both the barometric pressure and salinity into the meter menu. The customer appreciated that the preformed DO membranes made refreshing the electrolyte and membrane replacement extremely easy. The included wall mount cradle allowed the customer to keep their DO probe in their storage reservoir for real-time DO measurements. The built-in battery and tablet design of edge®DO offered the portability the customer needed for taking measurements around the greenhouse. Overall, the HI2004 edge®DO was a perfect fit for the nursery’s DO testing needs.


You have 0 items in you cart. Would you like to checkout now?
0 items
Switch to Mobile Version
Recent Updates
Subscribe Newsletter